In conjunction with Delaware Paddlesports I was able to complete this amazing Torqeedo Ultralight 403/AC install. Neil S took alot of time and reasearch for his complete install. He had many great ideas as he attempted to do a Drill Free motor install on his Hobie PA 12. We took a look at it and Neil allowed me to Drill 8 Small holes in his beloved Hobie. Here are the results!
Utilizing Sea-lect Designs Tru-Course Steering footbraces we were able to make the Hobie Pro Angler Torqeedo 403 completely Hands Free steering. I have done many installs in the past which integrated the Torqeedo with the Rudder hand steering of the Pro Angler. This is a great option for most users. However can be limited.
- Not Completely Hands Free
- Only about 120 degrees of total steering motion
- High Torque on the Hobie Rudder Steering System
The Install:
Parts Needed:
- Hobie Power Pole Mounting Kit
- Jackson Kayak Stainless Steel Rudder Cable Kit
- Jackson Kayak Rudder Tubing Kit
- Torqeedo 403/AC Kit
Plumbing the Hobie Pro Angler is pretty Simple. Drilling holes using 15/64″ drill bit for rudder tubing. This will make the hole tight on the tubing and should not require any silicone to seal although it is not below the waterline. Run cables. Secure tubing with wire clamps. I used the existing mesh pocket screws and the 2 screws beside the seat that hold the foam in place.
The footbraces are mounted below the ridge 1 1/2″ to the top. This requires a 1/4″ drill. Center the motor and using the foot brace small hex keys provided to center the foot pedals. Then tighten and swadge or cable clamp the ends. We cut back the top rail plates to allow the foot braces to operate freely.
Install Gallery:
Sea-Lect Designs Foot Brace Installed Left 
Managed Steering Lines 
Managed Steering Lines 
Motor Installed 
Stering Bracket Connection 
Cableing and Tubing to Motor Steering Bracket 
Sea-Lect Designs Foot Brace Installed
