In conjunction with Delaware Paddlesports I was able to complete this amazing Torqeedo Ultralight 403/AC install. Neil S took alot of time and reasearch for his complete install. He had many great ideas as he attempted to do a Drill Free motor install on his Hobie PA 12. We took a look at it and Neil allowed me to Drill 8 Small holes in his beloved Hobie. Here are the results!

Utilizing Sea-lect Designs Tru-Course Steering footbraces we were able to make the Hobie Pro Angler Torqeedo 403 completely Hands Free steering. I have done many installs in the past which integrated the Torqeedo with the Rudder hand steering of the Pro Angler. This is a great option for most users. However can be limited.

• Not Completely Hands Free
• Only about 120 degrees of total steering motion
• High Torque on the Hobie Rudder Steering System

The Install:

Parts Needed:

• Hobie Power Pole Mounting Kit
• Jackson Kayak Stainless Steel Rudder Cable Kit
• Jackson Kayak Rudder Tubing Kit
• Torqeedo 403/AC Kit

Plumbing the Hobie Pro Angler is pretty Simple. Drilling holes using 15/64″ drill bit for rudder tubing. This will make the hole tight on the tubing and should not require any silicone to seal although it is not below the waterline. Run cables. Secure tubing with wire clamps. I used the existing mesh pocket screws and the 2 screws beside the seat that hold the foam in place.

The footbraces are mounted below the ridge 1 1/2″ to the top. This requires a 1/4″ drill. Center the motor and using the foot brace small hex keys provided to center the foot pedals. Then tighten and swadge or cable clamp the ends. We cut back the top rail plates to allow the foot braces to operate freely.

Install Gallery:

The Jackson Big Rig FD/HD is a unique install as its transducer ready scupper is located in the center of the deck between the hull and the pod. At Delaware Paddlesports we used thru hullHobie Thru Hull 3 Way Plug Kit“> Hobie Thru Hull 3 Way Plug Kit. Drilling through the deck is not always the best option but in this case the only option. These unique fittings are gasketed waterproof and are the cleanest way to install on the Big Rig HD FD.

Utilizing the Lowrance 000-10606-001 Kayak Scupper Mount for Skimmer Type Transducers you can avoid many issues with a cap and bungee system. This scupper mounting system can accept many other brand transducers also. Although it is set for older model transducers it can be modified to work with the latest skmmer transducers from Lowrance.

Also for the Lowrance display head unit I used a Hobie Thru Hull 3 Way Plug Kit. Water tight and clean!

If you have any questions please feel free to contact me!

A quick video unboxing the New Mount and the contents within. Enjoy!