Damon Bungard of Jackson Kayak explains the install of a Power Pole Micro anchor on a Big Rig in this How To video. Also announced is the New Big Rig Battery tray!!!

 

Plans for fishing in RB are going to be rough for this weekend.Wind Guru

The wind forecasts are showing a demanding paddle and rough conditions. The stripers tend to like rough water though. Planning on Friday evening it shouldn’t be quite as bad. Then again going out early Saturday morning or just fishing right through. The forecast could change and typically will.

Hope to get some cool photos of the new Cuda and the Big Rig along with some nice fish!

For the local anglers if anyone cares to join up on Friday evening I will be on VHF channel 71. My handle is Yak Chum. Fishing location will be Raritan Bay between Staten Island NY and Keyport NJ region. Hoping to fish the Raritan reach channel. Not sure if I will get out that far though.

Good luck to anyone else fishing this weekend. BE safe and always wear your PFD.

This new Electronics Battery Box will accommodate a large 12v 12Ah sealed battery.  Before drilling holes in a dry box make sure your box will fit through the hatch on your kayak.

Dimensions of the battery

Length 5.94 inches

Width 3.86 inches

Height 3.74 inches

Weight 7.95 lbs

You can find these batteries new on ebay for $20 – $30. The higher amp hour is good for running fish finder chart plotter combos with color screens. These use a higher amount of amps than the black & white units the 7.5 Ah batteries just don’t perform as well for a full day of fishing.

PArts

List of Materials:

 

box with batt

Tools:

  • Drill
  • Heat Gun
  • Wire Crimps/Strippers
  • Drill bits/ Step Drill Bit

 

Install: 

wiringUsing pipe insulation fit the battery to the box. This will hold the battery in place so it doesn’t bounce around. Next drill a pilot hole using a 1/8″ drill bit. This will be the location of the cable penetration. You can pick pretty much any side. I would say avoid the top the bottom and the back. In this install I opted for the front under the handle. Once the pilot hole is drilled use the step drill bit to ream out the hole until the cable gland will thread in.

 

 

 

 

 

Once the cable gland is installed slide the cable with the connector through from the exterior. You will now pick 2 wires from the 4 to pair.  Use the two inline heat shrink connectors Crimp and heat the one side to seal. Now slide over the 3 inch piece of adhesive heat shrink tube. Connect the inline fuse wire and the ground wire. Attach the terminal ends and your DIY waterproof electronics battery box is complete.

 

batt box finished

Waterproof Battery Box Modifications & Upgrades <— Click for updated post!!!!